Maestro 32

Phoenix Automotive PA-6745 4.2T 4 Post Wheel Alignment Lift with air operated locks.

Comes standard with 2.5 ton air operated rolling jacking beam, front removable turntables and multi-directional rear slip plates on a 4800mm platform.

€6,580.50

Phoenix Automotive PA-6745 4.2T 4 Post Wheel Alignment Lift with air operated locks.

Comes standard with 2.5 ton air operated rolling jacking beam, front removable turntables and multi-directional rear slip plates on a 4800mm platform.

"WE STAND OVER OUR LIFTS, SO YOU CAN STAND UNDER THEM"

Description

Also suitable for the safe lifting of electric vehicles

  • Asymmetric post installation
  • Very stable bent posts
  • Without base frame
  • Two motors
  • Cold-rolled spindle
  • Nylon nut sets
  • Carriage with a combination of bearing by sliding blocs and rollers
  • Pushbutton control unit with alarm signal
  • Programmable top stop
  • Electronic synchronization
  • Double telescopic front and single telescopic rear arms, as standard
  • Possibility of parallel parking of arms
  • Internal arm locking system
  • Low minimum height

Standard colours:

  • Arms: red RAL 3020 / posts: grey RAL 7016

Versions

  • Available with different voltages
  • F = flex pad
  • CF = combiflex pad
  • CF-08 = combiflex 08 pad
  • DT/ST = double telescopic short arms, single telescopic long arms

Options

  • Available with 2 different portal heights; alternatively in-ground kit
  • LED lighting set
  • Power pack
  • Set of expansion bolts
  • Extra control unit
  • A large program of U and flex pads
  • Special colours available on request

Technical data

Lifting capacity, up to3,200 kg
Stroke length1,900 mm
Working height1,995 – 2,025 mm
Lifting / lowering time~ 40 sec.
Voltage3×230/400 V-50Hz – 25/16 A
Motor2 x 2.8 kW

Arm superstructure

Total height post2706 mm
Total height incl. portal4,050 / 4,350 mm
Drive-through width2,110-2,310 mm
Min. height95 mm
Width between posts2,365-2,565 mm
Total width – outer edges base plates3,120-3,320 mm
Total width – outer edges posts2875-3075 mm
Arm length front, min. – max.F DT: 540 – 850 mm
Arm length rear, min. – max.F ST: 900-1,425 mm

AUTOPSTENHOJ is a manufacturer and supplier of premium quality lifts and test equipment. Planning, consulting, assembly and technical support round off the AUTOPSTENHOJ range of services.